HOW TO FIT DOOR PT1
Grundog Skip
Watch: New Singing Lesson Videos Can Make Anyone A Great Singer
Right! I ent got very long to tell ya this But I'm gonna tell ya So you all know all right? Here we go This is how to fit ya door on the hinges Right, firstly If your home is very old, first check if the top corners are square One corner could be up to 1/4" (6 mm) higher than the other Use a large framing square if you have one or use a square piece of cardboard Measure the width of the opening in three places, because if a doorjamb is bowed, the width will be less in the center Measure the height of the opening at both sides of the doorway If they are not the same, check if the floor is level If the floor is higher at one side, the door should be cut to have this angle at the bottom Step 2 - buy a door to fit your frame Interior doors are normally sold only in widths of 28", 30", 34" and 36" Almost all are 80" high, so the door may have to be cut at the bottom The door should be only slightly narrower, (about 1⁄8 inch (0.32 cm), than the finished opening If the width of the door you buy is slightly too wide you can cut it to fit Step 3 - mark the door for trimming Allow for a gap of 1⁄8 inch (3.2 mm) along the doorknob side o the door If a gap is too narrow the door may not close in hot, humid weather because it will expand Allow for a gap of 3⁄8 to 1⁄2 inch (9.5 to 12.7 mm) under the door If the floor is not level, cut the door at an angle to allow for gap that is the same on both sides Allow for a larger gap at the bottom if the door swings out over a carpet Right, part 2 Ordering a door to fit Step 1 - trim the door to fit your frame if necessary Saw, plane, or use a belt sander to remove the wood up to the pencil marks, then sand the edges until they are smooth It is better to trim too little than too much If you're replacing an old door, you can lay the old door on top of the new door and trace around it to easily mark where your cuts will be If you must take off more than about 1⁄8 inch (0.32 cm) of the door, use a circular saw For smaller amounts, use a plane or a belt sander 2 - check if the door fits, with about an 1/8" gap on one side With shims under the door and someone else to help you hold it up, place the door in the frame and see if it fits properly If it doesn't fit, you will need to trim it again until the fit is perfect Mark the locations of the hinges now Place the door - oh shit The tracks finished Never mind F*ck you
Watch: New Singing Lesson Videos Can Make Anyone A Great Singer
Citation
Use the citation below to add these lyrics to your bibliography:
Style:MLAChicagoAPA
"HOW TO FIT DOOR PT1 Lyrics." Lyrics.com. STANDS4 LLC, 2024. Web. 1 May 2024. <https://www.lyrics.com/lyric-lf/13773040/Grundog+Skip/HOW+TO+FIT+DOOR+PT1>.
Discuss the HOW TO FIT DOOR PT1 Lyrics with the community:
Report Comment
We're doing our best to make sure our content is useful, accurate and safe.
If by any chance you spot an inappropriate comment while navigating through our website please use this form to let us know, and we'll take care of it shortly.
Attachment
You need to be logged in to favorite.
Log In